BCSetQuietZone

ERRCODE BCSetQuietZone ( t_BarCode *  pBarCode, LPRECT  prQuietZone, e_QZMUnit  eQZUnit   ) Sets quiet-zones and units used for quiet-zones. Specifies the required quiet-zone and the respective measurement units. A quiet zone is an unprinted area to the left / right of a linear barcode. 2D-codes may require quiet-zones at the top/bottom too. Quiet-zone functionality is currently implemented for linear barcodes (left and right side) and for Data Matrix (all sides) Note: Currently you can specify the quiet zone in [modules] only, so the width of the quiet zone depends on the module width (respectively “narrow bar width X”) Parameters: [in]  pBarCode  Pointer to barcode structure. [in]  prQuietZone  Pointer to rectangle that specifies quietzone. [in]  eQZUnit  Unit for quietzone-values (mm, Modules, mils...). Return values: ERRCODE  ErrOk (0) in case of success. Non-zero if error occurred. See also: BCGetQuietZone()

---

© 2007 All rights reserved by TEC-IT Datenverarbeitung GmbH
Generated on Tue Nov 27 14:28:02 2007 for TEC-IT TBarCode Library 8.0.0 with doxygen 1.5.3