BCGetBearerBarType

e_BearerBar BCGetBearerBarType ( t_BarCode *  pBarCode  )  Gets the current type of the bearer bars. By default, bearer bars are deactivated (eBearerBar_None). To activate bearer bars the bearer bar type has to be set to eBearerBar_TopAndBottom or eBearerBar_Rectangle. The bearer bar width has to be set to -1 (for the default minimum bearer bar width) or a value > 0. The vertical bearer bar is only displayed if you have set a quiet zone at left and right >= 12 modules (the quiet zone is necessary to keep the bar code readable). Parameters: [in]  pBarCode  Pointer to barcode structure. Returns: The bearer bar type. Remarks: Usually bearer bars are used with ITF-14 only. The bearer bar was introduced to equalise the pressure exerted by the printing plate over the entire surface of soft materials. It also enhances reading reliability by helping to reduce the probability of misreads by skewed scanning beams. Bearer-bars are usually drawn below and above the barcode (ITF-14) and are used to avoid partial scans. They can be also drawn as a rectangle. For some barcode symbologies with synchronization bars (like EAN8) you must not enable bearer bars. See the Barcode Reference for more information. See also: BCSetBearerBarType(), BCGetBearerBarWidth(), BCSetBearerBarWidth()

---

© 2007 All rights reserved by TEC-IT Datenverarbeitung GmbH
Generated on Tue Nov 27 14:28:02 2007 for TEC-IT TBarCode Library 8.0.0 with doxygen 1.5.3